Salicylic acid from acetylsalicylic acid

I am going to attempt to use a base ester hydrolysis to deacetylate acetyl salicylic acid that I collected from aspirin tablets in an earlier post.

The conversion to salicylic acid is only a few steps. First, the acetyl salicylic acid is dissolved in a solution containing about equal mass sodium hydroxide. Then it is left to reflux for half an hour and the solution is combined with hydrochloric acid until the pH reaches 1. The salicylic acid precipitates as the pH decreases and it is important to take the pH as far down as possible. The precipitate is then filtered and washed several times with cold water. I then left the product to dry in the buchner funnel with a vacuum being pulled. To further dry it, I left it in an evaporating dish inside an oven.

                             

Comments

  1. Larysa BohdanaFebruary 11, 2021 at 6:11 PM

    I was diagnosed with COPD with 55-60% lung capacity and HPV, My doctor just said all the crying , stomping your feet will not change it so just accept it and basically patted me on the back and sent me home to die. I was devastated and was afraid to do anything. I stopped riding my bike, I was afraid to do anything that would cause any exertion. It consumed my thoughts with every breath and the fear of what to expect was almost more than I could deal with. So I couldn't get myself all time I decided to find a herbal cure online and I came across Doctor Itua on how he cure several people suffering from Hiv, and Herpes I gave him a call on this Number +2348149277967 also chat on whatsapp he gave me all the details about the cure i paid him for the medicine after 5 working days i receive my herbal medicine ,I use it for two weeks that is how I get Cured and today I'm living healthy and fine I give him thanks also promise him to testify about his work,He Can also cure the following diseases..Copd,Herpes,Alzheimer's disease,carcinoma.Asthma,Allergic diseases.Parkinson's ,Epilepsy,Cancer,HPV,Wart Remover,Ance,Fibromyalgia,Hiv,Hepatitis,diabetes,Coeliac disease,Infertility, Asthma.Contact...drituaherbalcenter@gmail.com..Whatsapp Number...+2348149277976

    ReplyDelete

Post a Comment

Popular posts from this blog

Using Airplane Transponder Data to Characterize Antenna Performance

Image
Hi All, Recently I obtained some low-noise amplifiers in order to better receive NOAA GOES satellites. A low-noise amplifier however is no good without a decent antenna. Most often people use these 2.4 GHz wifi antennas modified to operate at the GOES downlink frequency. This typically gives very good results but it's pretty challenging to DIY a satellite dish. An alternative to satellite dish type antennas is the highly directional yagi-uda antenna. Yagi-uda antennas are pretty (seemingly) simple to build so one night I made a first pass at throwing one together. Alas the satellite signal still did not appear (probably due to my poor assembly). Instead of scrapping the inadequate antenna I decided to try and figure out if adding the passive elements actually did anything to the directionality of the yagi-uda antenna versus a regular dipole antenna. To do this without some sort of signal source is typically impossible and so people resort to modelling programs that calculate the ga...
Read more

Microstate table for a d3 electronic configuration.

This was just a test to see if I could put LaTeX formatted tables into this webpage MathJax example $$\begin{array}{|c | c | c | c | c|} \hline \begin{array}{c}\end{array} & \frac{3}{2} & \frac{1}{2} & -\frac{1}{2} & -\frac{3}{2} \\ \hline 5 & \begin{array}{c}\end{array} & ^{2}H\begin{array}{c}^{2}H(2^+,2^-,1^+)\end{array} & \begin{array}{c}(1^-,2^-,2^+)\end{array} & \begin{array}{c}\end{array} \\ \hline 4 & \begin{array}{c}\end{array} & ^{2}G\begin{array}{c}^{2}H(2^+,2^-,0^+)\\^{2}G(2^+,1^+,1^-)\end{array} & \begin{array}{c}(0^-,2^-,2^+)\\(1^-,2^-,1^+)\end{array} & \begin{array}{c}\end{array} \\ \hline 3 & ^{4}F\begin{array}{c}^{4}F(2^+,1^+,0^+)\end{array} & ^{2}F\begin{array}{c}^{2}H(2^+,2^-,-1^+)\\^{2}G(2^+,1^+,0^-)\\^{4}F(2^+,1^-,0^+)\\^{2}F(2^-,1^+,0^+)\end{array} & \begin{array}{c}(1^-,2^-,0^+)\\(0^-,2^-,1^+)\\(0^-,1^-,2^+)\\(-1^-,2^-,2^+)\end{array} & \begin{array}{c}(0^-...
Read more

Perturbation Theory in Mathematica

Hello, I've wanted to implement perturbation theory in mathematica for some time now. Here, I've done so for a non-degenerate time independent case. Specifically for the one dimensional harmonic oscillator (not quantum because symbolic constants just make the computation take longer). I tested it on some problems from Shankar's quantum mechanics book and it works. The things you'll need are: 1. Eigenvalues and eigenfunctions for a solved case (in our case the harmonic oscillator). $$H0=\frac{\text{$\#$1} x^2}{2}-\frac{\nabla _{\{x\}}^{}\text{$\#$1}}{2}\&$$ \[ScriptCapitalH]0 = -(1/2) Laplacian[#1,{x}] + 1/2 (x^2) #1 &; \[ScriptCapitalH]1 = x^2 #1 &; \[ScriptCapitalH] = \[ScriptCapitalH]0[#1] + \[ScriptCapitalH]1[#1] &; {eigList, wfnList} = DEigensystem[\[ScriptCapitalH]0[u[x]],u[x],{x}\[Element] FullRegion[1], nmax, Method -> "Normalize"]; where nmax is the maximum number of eigenvalues/eigenfunctions to compute. ...
Read more